Ritter WES 45 Operations Instructions download pdf (Page 9)

6



Unfold the graphics in the

front and rear backs of the

book.

Please read the instructions

thoroughly before starting

to use the appliance. Keep

these operating instructions

in a safe place and enclose

them with the appliance

when it is handed on.

INTENDED USE

The scales are used for

weighing household-type

foodstuffs.

Using the scales in a man-

ner other than they were

intended for may damage

them. All warranty and liabil-

ity claims will be rendered

null and void.

GENERAL SAFETY

INSTRUCTIONS

Caution:

To avoid damage to the

appliance please observe

the following safety in-

structions:

– Never immerse the appli-

ance in water. Never leave

the appliance out in the

rain or subject it to any

other form of moisture.

– The appliance is to be used

for household purposes

only and not commercially.

– Do not place any articles

on the scales which weigh

more than the maximum

load capacity (5000g / 9lb

15oz).

INITIAL START-UP

Preparation

• Remove the appliance

carefully from the packaging.

• Remove all packaging

parts and keep these to-

gether with the packaging in

a safe place.

• Turn the underside of the

scales upwards.

Pull the pull-out section

so that the battery compart-

ment(6) is made accessible.

• Pull the red insulating strip

out of the battery compart-

ment to activate the previ-

ously inserted battery.

• Use the selector switch (5)

to choose the required meas-

uring unit (grams/pounds).

• Clean the appliance before

allowing it to come into

contact with any food (see

CLEANING THE APPLIANCE).

Setting-up the appliance

Caution:

Never set the appliance

down on hot surfaces or

close to naked ﬂame.

The scales can be used

in drawers or on any level

surface.

The pull-out section can

be used to enable the scales

to match the width of the

drawer.

WEIGHING

The measuring unit on

the scales can be switched

between grams and pounds

(Selector (5)). A maximum of

5000g or 9lb 15oz can be

weighed.

Switch the scales on

by brieﬂy pressing the tip

switch(3).

Note:

During the start-up phase

(display: 88888) do not place

any food onto the scales.

If the weighing container is

not to be part of the weigh-

ing process:

Place the container onto

the scales (1) and press the

tip switch again.

The display is reset to 0. Fol-

lowing this only the food to

be sliced is weighed.

Note:

If “-----” appears in the

display, the scales’ weighing

range has been exceeded. In

such an instance, weigh the

food to be sliced in several

portions successively.

Additive weighing (e.g.

when mixing several

ingredients)

• Press the tip switch again

after weighing an ingredient.

The display is reset to 0. The

next ingredient can now be

weighed.

Switching off the scales

• Reset the display on the

scales to 0 (remove weighed

material or press tip switch).

• Press the tip switch. The

scales are switched off.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Comments to this Manuals

No comments