Ritter EBT Installation Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
9
MOUNTING BREAD BIN LID
FASTENINGS
Place the bread bin (1) into the (inserted)
drawer.
Shorten the supporting pipe (3) to the
correct length (inner carcass width minus
8 mm).
If necessary, route the supporting pipe
into the lid rack (6).
Align the supporting pipe parallel to the
bread bin lid (2) at a distance of 16 mm
(Figure D).
Place the bread bin lid onto the bread bin:
The "ritter" emblem should be visible at
the front.
The bread bin lid should contact the
front of the drawer
Figure D:
Pull the drawer out far enough, so that
the supporting pipe makes contact with
the front edge of the carcass side.
Mark the upper edge of the supporting
pipe on the left and right of the inside of
the carcass.
Remove the bread bin lid and the bread
bin.
Remove the drawer.
Figure E:
Use the drill template and a centre punch
to mark the following on the right-hand of
the carcass interior:
the holes for the right retaining
bracket (10)
the holes for the lid carrier (11)
Figure F:
Use the drill template and a centre punch
to mark the holes for the left retaining
bracket (10) on the left of the carcass
interior.
Drill the marked holes (Ø4.5 mm x 10 mm).
INSTALLING VENTILATION BEZEL
Drill the hole for the ventilation bezel (7)
(Ø44 mm):
on the rear side of the carcass
in the centre, level with the bread bin
Insert the ventilation bezel.
FINALISATION
Insert the retaining brackets (10) into the
bores and fasten them in place using the
fastening screws (13).
Insert the bread bin lid (2) with the sup-
porting pipe (3) into the retaining brack-
ets.
Mount the lid carrier (11) using the fasten-
ing screw (14).
Insert the drawer.
Place the bread bin into the drawer.
Check the position of the lid carrier:
The lid carrier ts ush to the front of
the bread bin
The lid carrier must not contact the side
of the bread bin when the drawer is
pulled out
If necessary, adjust the position of the lid
carrier (6).
Tighten all screws.
English
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Comments to this Manuals

No comments