Ritter AES 52 S Operations Instructions download pdf (Page 20)

13

Englisch

ASSEMBLY AND

INSTALLATION

Please refer to the illustrations

(R to X) provided at the front and

back of this manual.

Safety instructions

To avoid personal injury or dam-

age to the appliance, please

observe the following safety

instructions:

– This appliance may only be

assembled by qualied person-

nel. ritterwerk will not be held

liable for the consequences

of improper and/or incorrect

assembly.

– The mains cable must be

positioned to ensure that the

appliance can be fully folded

down into the drawer without

trapping the cable. The mains

cable must be routed directly

and without obstruction from

the built-in system to the sock-

et, which must be mounted in

the oor unit.

– Unplug the cable from the

socket before assembly.

Installation conditions

The following dimensions repre-

sent minimum values:

– Body width: 300 mm,

– Clearance height for drawer

base/crossbeam:

80 mm (not allowing for stor-

age of the slice tray)

85 mm (allowing for storage of

the slice tray)

– Pullout clearance for front

edge of worktop/inner edge of

front drawer panel: 412 mm

– Clearance width (usable)

Drawer base: 184 mm

– Width of appliance (when

folded down): 195 mm

The drawer base should be at

least 16 mm thick.

At a nominal length of 500 mm,

the drawer’s roller mechanism

should have a static load capacity

of at least 40 kg.

Delivery contents

14 Clamping xture (front)

15 Clamping xture (rear)

16 Lock clip

16a Slide bar lock

17 Countersunk screws

four 4 x 17

18 Countersunk screws

two 3 x 16

Selecting a socket

Note:

A surface-mounted socket (that

complies with VDE/DIN 49440,

ÖVE, SEV) must be mounted

either on or behind the rear

panel at drawer height.

The mains cable connection

to the socket should be routed

under the rear crossbeam or the

underside of the work top and as

high up as possible in the corner

of the oor cabinet‘s rear panel.

It must be possible to slide the

drawer in fully while the mains

plug is in the socket.

The mains plug must be eas-

ily accessible to the user to

ensure that the appliance can

be unplugged from the mains as

required (for example, prior to

cleaning).

Mounting the multi slicer

• Pull out the drawer until it

stops.

R

Place the drill template in the

drawer as shown in the illustra-

tions.

• Mark the positions for the four

drill-holes required.

• Use a 1 mm drill to pre-drill the

marked positions.

S

Use the four countersunk

screws provided (17) to bolt down

the two clamping xtures (14

and 15).

• Use the two countersunk

screws provided (18) to attach

the lock clip (16), together with

slide bar lock (16a), to the front

clamping xture (14).

• Leave the lock clip open.

T

Pull out the pull-out tting on

the multi slicer.

U

Position the multi slicer over

the two clamping xtures in the

drawer.

V

Slide the multi slicer towards

the front of the drawer until it

locks into place on the two clamp-

ing xtures.

W

/

X

Press down on the lock

clip until it snaps into place.

• Plug the cable back into the

socket.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 75 76

Comments to this Manuals

No comments